单项选择题
Which command can be used to determine the type of cable attached to the Serial 0/0 interface on a router?（）
A. show interfaces serial 0/0
B. show running-config
C. show version
D. show controllers serial 0/0
E. show ip interface
F. show line serial 0/0
相关考题
-
单项选择题
TestKing.com is configuring the serial interface of a Cisco router to connect to the router of a new ISP. A full T1 is being used for the Internet connection. After issuing the show interface serial 0/0 command, it is observed that the interface is UP and the line protocol is DOWN. Which of the following commands could fix this problem?（）
A. Border# copy running-config startup-config
B. Border(config)# no shutdown
C. Border(config-if)# encapsulation ppp
D. Border(config-if)# no cdp enable
E. Border(config-if)# ip routing -
单项选择题
You have just installed a new web server on the Testking network. You are required to ensure that the web server is accessible from the Internet. The network uses private addressing, so an IP-to-registered address mapping is required.To do this, you enter the following command:TestKing(config)# ip nat inside source static 192.168.2.1 198.18.1.254 You unsuccessfully try to ping the Internet from a PC host on the LAN. During the troubleshooting process, you enter the "show ip nat translations" command but the output is blank. What is the most likely cause of the problem?（）
A. The keyword overload is missing from the command.
B. The NAT pool must be defined first.
C. An access list must be defined to create static NAT translations.
D. The interfaces must be configured for NAT.
E. None of the above -
单项选择题
In order to troubleshoot an issue with the Testking frame relay network, you log into a remote router via a telnet session and issue the command "debug frame-relay lmi". After a long wait, you fail to see any output. What could be the cause of this problem?（）
A. The IP addresses are configured incorrectly.
B. Frame Relay LMI messages not displayed in real time.
C. The administrator must issue the enable frame-relay lmi debug command.
D. The administrator must issue the terminal monitor command.
E. Debug messages can only be received once through the console port.
F. The administrator must issue the show frame-relay lmi vty 0 4 command
