单项选择题
A customer has downloaded new firmware files for the IBM support Web Site. Which of the following is the correct method for updating the firmware for the QLogic Intelligent Passthru Module using the command line?（）
A.Transfer the file to the FC module using FTP； use Telnet to the FC module to start the update
B.Use Telnet to the AMM to transfer the file using TFTP； start the update
C.Transfer the file to the FC module using Secure Copy Protocol （SCP）；use Telnet to the FC module to start the update
D.Start the update and enter FC module IP address when prompted
相关考题
-
单项选择题
AmedicalcustomerhasarackwithfourBladeCenterHchassisthathavebeenoperatingnormallyforseveralmonths.Afterinstallinganewrackofserversinthedatacenter,thesystemadministratornoticestheblowersintheBladeCentershaveincreasedtheirspeed.Whichofthefollowingcausedthisproblem?（）
A.The room temperature has reached 23C (73.4F).
B.A Blade within the chassis has been shut down.
C.The ambient temperature in the data center has increased
D.One of the additional System X servers in the BladeCenter rack has failed. -
单项选择题
WhichofthefollowingisthecorrectproceduretoupdatetheBIOSonLS42bladeswithoutusingtheAMM?（）
A.Insert the Update eXpress Service Pack Installer (UXSPI) CD, boot the LS42 blade and follow the prompts
B.Boot the blade to the Bootable Media Creator (BoMC) CD and follow the prompts
C.Press F1 when the LS42 system is booting, select Update BIOS, insert the diskette into the diskette drive, and select OK
D.Use the Remote Supervisor Adapter virtual disk -
单项选择题
AcustomerhastwoEthernetSwitchModulesinstalledinanIBMBladeCenterEnterprisechassis.Themoduleswereconfiguredidentically.TheEthernetmoduleinbayonewasinadvertenlyresettofactorydefaults.Whichsolutionreturnsthemoduletothecustomer-specificconfiguration?（）
A.Back up the configuration from Ethernet module in bay 2 and restore it to the module in Bay 1 using the switch CLI or Web interface
B.Swap the modules, which will automatically resynch the settings stored in the Advanced Management Module
C.Back up the configuration of the Ethernet module in bay one and restore it to the Ethernet module in bay two using the AMM
D.Restore the configuration from NVRAM using the Switch Module Web interface
