单项选择题
The ping loopback hangs with no output.Which of the following is the most likely cause?（）
A.The loopback interface is down and resolv.conf is configured.
B.The loopback is not in /etc/hosts and resolv.conf is configured.
C.The loopback interface is down and resolv.conf is not configured.
D.The loopback is not in /etc/hosts and resolv.conf is not configured.
相关考题
-
单项选择题
An administrator has set up serverA and serverB to use the /etc/hosts.equiv file so that applications on serverA can remotely run commands on serverB. Which command will verify if a new user from serverA is trusted on serverB?（）
A.As the root user from serverA run the command rhost serverB
B.As the root user from serverA run the command rlogin serverB
C.As the desired user from serverB run the command rhost serverA
D.As the desired user from serverA run the command rlogin serverB -
单项选择题
A system is experiencing packet routing problems,when the administrator runs netstat -nr the following default routes are displayed: default165.253.251.1UG51601304 en8--default 192.168.50.1UGH01590450 en4-- Assuming the first route is correct. How can the administrator remove the incorrect default route?（）
A.route delete default 192.168.50.1
B.access smit with the route_remove shortcut
C.chdev -l inet0 -a delroute=net,-hopcount,0,,192.168.50.1
D.flush the routing table from the console and configuring the 165.253.251.1 route -
单项选择题
An administrator issued a command to update thefirmware of an Ethernet adapter on a partitioned system, but received an error. What is the most likely cause of the problem?（）
A.The adapter must be taken offline prior to the firmware update.
B.The system has not been rebooted since the adapter was added to the LPAR.
C.The adapter must be assigned to the service partition prior to updating the firmware.
D.The adapter must be dynamically removed from the LPAR prior to updating thefirmware.
